It is an exciting moment to deal with dust extraction and create a new workstation! In the end, it is a good feeling to help you complete the pipeline equipment at hand.
However, mistakes are usually made to prevent progress, or at least due to waste of time or waste of money.
Pipeline installation is no exception. It looks simple.
Get the pipeline, connect it, put it on the wall and the roof … right? Well, this method can sometimes lead to problems!
Below is some common problems related to pipeline installation. These problems are most likely to be implemented.
These views were proposed for a long time, and they all made these mistakes.
Spending more energy to make the right effort for the first time may cause pain, rather than trying to completely correct all pain.
Check the list below. If you think there should be more errors, you need to avoid it, please contact us at any time!
1) Pipelines of error size
Although this seems to be a simple avoiding errors, it is also the most error! If your pipeline size is too small or too narrow, the system will easily block and eventually reduce airflow.
This may lead to overheating, which will corrode and damage the system over time.
A simple method to determine whether your pipeline is insufficient size, which is caused by or whistle sounds caused by the system.
If you are not sure of the size suitable for your system, please contact our support team at any time, and they can help you find the best solution.
Please read another: 7 steps to open small enterprises online
2) Direct 90 -degree elbow connector
It is difficult to place the elbow because they always reduce the efficiency of the system.
Any curved or turning in the pipe system will greatly reduce air circulation, so it is best to try to keep them at the lowest.
If the elbow -free system can be installed, it will be ideal.
But at present, trying to use more blunt angles that are not 90 degrees, so it maintains low resistance and high voltage.
The liquidity of one meter long bread is 10 times higher than the liquidity of the pipeline.
This is mainly due to their flexible shape. It is also easy to pierce, split and air leakage-this may be a huge disadvantage for your system.
The excessive use of these hoses can also lead to excess noise, which may loud according to the length and size.
It is best to keep only one or two hoses and always make sure to choose the best quality you can find.
Please read another: The complete guide to leisure clothing for women’s enterprises
When you design the dust extraction system, please consider the pipeline material.
Although it is recommended to use smooth wall tube to maintain lower resistance, there are many other choices to choose from.
Usually, you can find anything from plastic pipes, spiral tubes, smooth pipes and even sewage pipes (however, usually used to extract wood chips).
The use of plastic pipes on steel pipes may be cheaper, but more risks-sometimes lead to explosion.
In any case, minimizing air resistance is essential for an effective extraction system.
Therefore, it is best to use a soft curve and a large radius to obtain smooth interior to facilitate airflow.
5) Sealing issues
Finally, to have the best pipeline solution, sealing needs to be the primary task.
Any error -sealing pipe can leak directly to the room and wall.
This means that any air in the pipeline is wasted and may cause overheating components!
Always ensure that the use of high -quality sealing solutions, and check the QuickFit products we have unique fixture design, which can prevent air from escape.
Always ensure the pressure of each pipe and connector.
Please also read: 18 methods to make money now
Now you know some of the major common errors-it should be easy to avoid them!
If you like this blog and want to read more? See this page
